Protect America Simon XT Manual de instalación Pagina 27

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 29
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 26
Simon XT User Guide
27
Frequently Asked Questions
How do I test my security system?
Please see "Test Your System Monthly" on page 23 of this manual, or Live CHAT on our website
and a representative will walk you through testing your security system.
How many access codes can my Simon XT hold?
The Simon XT control panel can store 8 user codes and 1 duress (panic) code in addition to
the master code.
Why is my system status light on?
The system status light will remain lit while a secured door or window is open. If all secured doors
and windows are closed and the system status light is still on, press STATUS (
Status
) to have your
panel voice any pending status messages.
How do I clear alarms from the memory?
To clear alarms in the memory, press STATUS (
Status
). Your Simon XT will voice the list of alarms
stored in memory. When your panel has spoken all alarms, press DISARM (
Disarm
) to clear the
memory.
Why does my system display a low battery?
Your system will display a low battery when either the batteries in your sensors or the back-up
battery in your Simon XT becomes low. Make sure that your battery is connected (see page 5 of
this manual). The back-up battery is rechargeable and should be fully charged within 24 hours of
regaining electrical power.
Why does my system display sensors in failure?
Your Simon XT will indicate sensor failure when it is unable to communicate with a sensor. This
could be due to a missing sensor, damaged sensor, or a dead battery. For assistance visit our
website at www.protectamerica.com and Live CHAT with a representative.
Why does my system beep 6 times every minute?
These are called trouble beeps; they are used to indicate trouble conditions with your panel. Press
STATUS (
Status
) to have your Simon XT voice any trouble conditions.
Why does my system beep after I arm it?
After you arm your system, it will beep for the exit-delay time—the time in which you can exit your
home before it is armed. The beeping will grow more frequent as the end of the exit-delay time
approaches. When the exit-delay time has expired, the beeping will stop and the system will be
armed.
Vista de pagina 26
1 2 ... 22 23 24 25 26 27 28 29

Comentarios a estos manuales

Sin comentarios