Protect America Simon XT Manual de instalación Pagina 7

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 16
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 6
5
Set the Clock, Chime, and Alarm
Setting the Clock
Press SCROLL UP ( ) until the display reads "Set Clock," and then press ENTER ( ).
Enter the master code, then press ENTER twice ( ). If no master code has been set, the default master code is 1234.
The hour should be blinking. Type in the current hour using the KEYPAD then press ENTER ( ).
The minute should be blinking. Type in the current minute using the KEYPAD then press ENTER ( ).
Press SCROLL UP ( ) to select "am" or "pm," then press ENTER ( ).
Press STATUS twice (
Status Status
) to return to the main menu.
Set the Siren
A high-volume siren will sound if there is an intrusion while the system is armed.
Press SCROLL UP ( ) until the display reads, "System Programming," then press ENTER ( ).
Enter the master code, then press ENTER ( ). If no master code has been set, the default master code is 1234.
Press SCROLL UP ( ) until the display reads, "Siren Options," then press ENTER ( ).
Press SCROLL UP ( ) until the display reads, "Panel Piezo Alrm," then press ENTER ( ).
Press SCROLL UP ( ) to select "on" or "off" then press ENTER ( ).
Press STATUS three times (
Status Status Status
) to return to the main screen.
Set the Chime
If the chime is on and the system is disarmed, the Simon XT panel will use voice notication when doors or windows are opened.
When the chime is on, a bell icon is shown on the display.
Press SCROLL DOWN ( ) until the display reads, "Chime," then press ENTER ( ).
Press SCROLL UP ( ) to select “on” or “off,” then press ENTER ( ).
(Note: It is recommended that the chime be turned on while installing sensors.)
Press STATUS (
Status
) to return to the main menu.
4
Programming the Simon XT requires keys to be pressed in order, with little or no
delay. It is recommended that you familiarize yourself with these steps before
beginning. For initial programming, the default master code is 1234 (
).
The settings below are optional and not required for the Simon XT to operate.
Vista de pagina 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Comentarios a estos manuales

Sin comentarios